Pressure Tubes for T-Series and XPC Series Gravity Feed Guns mt-Plastic Create perfectly spaced holes at

Create perfectly spaced holes at 1-1/4" (32 mm) increments

90° geometry can be used on profiles to make invisible miters

High-Density-Urethane (HDU Board)

Replacement drill bit for the Kreg 5mm Shelf Pin Jig

Then merely replace the tip with a new cutter when all the factory edges have dulled

Pressure Tubes for T-Series and XPC Series Gravity Feed Guns mt-Plastic Create perfectly spaced holes atOverview For T Series Gravity and XPC Gravity Spray Guns. Pressure tubes with check valve installed. Available only in packs of 5. These tubes fit all Fuji spray guns. If clogged, the check valve cannot be taken apart, however, they can be soaked in thinner for up to 30 minutes to free any blockage. Please note: The gravity pressure tubes are likely longer than you may need. When cutting them to reduce length ensure that they have a straight edge to