AudioFrog TP-50V2 - Tweeter Protector for use in Active Systems drop down monitor Installation manual

Installation manual

parking guidelines

These Alpines are a great match for a factory or aftermarket stereo

crossover point: 3500 Hz at 18 dB/octave

IPX5 rated for water resistance

AudioFrog TP-50V2 - Tweeter Protector for use in Active Systems drop down monitor Installation manualDescription The TP 50V2 is intended to protect your tweeters from electronic component failure, DSP software glitches or failures and from erroneous crossover settings. The TP 50V2 will remove low frequency content from the signal and is only active below the crossover you implement in the DSP or the amplifier. The TP 50V2 will not protect against too much power above the crossover caused by bad gain setting procedure, an amplifier thats way too